Carpets are easy to maintain when you know the proper treatment and fixes. If not, you will end up spending more on repairs and maintenance over the years. The carpet is one of the largest investments that can burn a hole in your wallet when you accidentally burn a spot on the rug or spill a glass of wine. But you don’t have to hire a professional to fix the spots to replace the carpet. Learning how to solve such issues will not only prolong the lifespan of the carpet, but all save you money.
As a homeowner, you can save money just by fixing common carpet problems on your own. With issues like loose spots, burns, and stains – we will help guide you through it. In this article, we will show you how to fix three of the most common carpet problems.
Here are 3 DIY carpet fixes every homeowner should know.
Re-patch Damaged Spots
You can fix a small tear or hole by using techniques that will make the damage invisible. All you will need if a small spot of carpet that matches the area. If you are unable to find a matching material, you can always take some from inside the closet. While tearing up another area of carpet might sound extreme, it will be a whole lot cheaper than replacing the entire carpet floor. Be sure to get a carpet knife that has sharp, replaceable blades. You will also need a roll of one-sided carpet tape that will reinforce with the mesh.
Soggy Carpet Pads
When the carpet gets soaked, you will need to act fast. The longer the carpet stays wet, the more it will stretch out and even begin to mold. If the large portion of the carpet is wet, consider a replacement. However, if there is only a small area that is soaked, you can tear out the soggy pad. Do so by grabbing the carpet with pliers and pull the carpet off the strip. Get rid of the soggy pad and replace it with a new one.
Fix Pulled-out Carpets
Did the carpet get loose from the metal threshold? You can fix it yourself within minutes. However, if the damage reaches over an inch, the repair won’t look as great as it once was. All you will need as a new metal threshold, carpet knife and a knee kicker, which can be found at a rental center.
The repair is will be easier if you remove the door first. You can do this when the door is in place, but risk the chances of scratching the door. Be sure to pry up the lip of the metal threshold with the use of a screwdriver or a flat pry bar. Once the carpet edge is in good shape, you will then be able to place the new metal threshold where the previous one was.
So, the next time you find yourself in a carpet situation, be sure to follow these 3 DIY carpet fixes.